Advantages and disadvantages of Silicon Phosphorus Crystal
Advantage
1. Easy to use: no power consumption, no increase in the resistance of the water system, usually no need for special maintenance, only need to add "silicon phosphorus crystal" once every 3-6 months.
2. Low cost: the dosage of silicon-phosphorus crystal is about 1-5 grams per ton of water. After the equipment is put into operation, the consumption of the medicine can be observed from the window hole of the dosing tank.
3. Hygiene and safety: Silicon Phosphorus Crystal is a chemical water treatment agent that can be safely used in drinking water systems. The ingredients of the agent comply with the standards of FAO/WHO (United Nations Food and Agriculture Organization/World Health Organization) and have been internationally recognized as NSF. ” (National Foundation for Environmental Sanitation).
4. The effect is obvious: the silicon phosphorus crystal glass ball is composed of polyphosphate and silicate, which is sintered into a glass-shaped ball at high temperature. Silicon and phosphorus crystals are slightly soluble in water, and form a protective film on the tube wall that can automatically repair, preventing the corrosion and scaling of metal materials by microorganisms in the water. In addition, it can penetrate into the rust and make it fall off and clean the pipe wall.
Shortcoming:
1. Limitation of use: Silicon phosphorus crystal needs to be equipped with a special silicon phosphorus crystal dosing tank, and there must be water flow; when the concentration of silicon phosphorus crystal in the outflowing water reaches 3-5ppm, the anti-corrosion and scale inhibition effect can reach 80% Above, if the water source is still, the effect will be greatly reduced.
2. Time limitation: Silicon phosphorus crystal will increase its effluent concentration with soaking time and ambient temperature. There is a drainage process in the middle process that will change its concentration value. When the concentration is too high, the corresponding heavy metals will also increase, and drinking at this time will be harmful to the human body.
3. Environmental requirements: it cannot be used in a closed circulation system. The treated water cannot be heated repeatedly after boiling. Not to be used for water temperatures over 100 degrees, such as steam boilers.
